IGUS | energy chains

139 chainfix | Strain relief elements 3DCAD, configurators, service life calculation andmore X www.igus.eu Steel and stainless steel clamps - for maximum tensile forces From page X 1408 Even for larger hose and cable diameters up to 50mm ● chainfix clamps with up to 15mm reduced installation height and up to 3.5 times higher force absorption compared to conventional clamps ● Marking of the correct installation direction ● Optional: CFXL clamps for increased holding force for heavy-duty applications ● Also available with other components as multi-clamps or pneumatic clamps chainfix tiewrap plates - universal, bolted or clip-on From page X 1420 The tiewrap plate is integrated on the end of the mounting bracket, and cables and hoses can be fixed using cable tiewrap ● Quick and easy to assemble (clip on) ● The tiewrap plate is also captivated by the fixation of the mounting brackets ● Longer service life for cables ● Space-saving design ● Assembly in the C-profile of the KMA (plastic/metal mounting brackets) possible chainfix tiewrap plates - five optional variants From page X 1422 Version 1: Tiewrap plates with clip-on connection to C-profile - be clamped directly into the C-profile without screws ● Version2: Strain relief tooth for Top-hat (DIN) rail 15 (TS92.31) ● Version3: Integrated strain reliefs for series R E2 e-tubes ● Version 4: Tiewrap plates for fixed crossbars ● Version 5: Tiewrap plates for crossbars ● Attachable tiewrap plates can be detached and relocated, using only a screwdriver as a lever. CFU.V - Strain relief with innovative honeycomb design From page X 1426 ● 80% faster to fill (compared to a CFX strain relief), openable from both sides for installation in seconds ● Flexible honeycomb design for high holding force of the cables ● Tribologically optimised honeycombs for best hold ● Di ff erent cables with diameters of 2mm -17mm can be easily strain relieved ● Cables can be easily replaced ● Simple positioning of the cables Strain relief separators - separator with integrated strain relief teeth From page X 1428 For easy strain relief with cable tiewraps ● Can be integrated in mounting bracket ● To be fitted at the first and last e-chain ® link ● Strain relief separator can bepositioned as required ● Easy to assemble without any screws ● Cost-e ff ective ● For most series from stock CFV - stepped strain relief for use outside of the e-chain ® section From page X 1432 Easy strain relief for cables, even inenclosede-tubes ● Stepped strain relief - good access ● Matching for e-chains ® and e-tubes ● Easy retrofit assembly possible ● Simple installation into top-hat rails and C-profile on KMA mounting brackets CFN - chainfix nuggets for C-profile and top-hat (DIN) rail 35 From page X 1433 Simple strain relief - pre-assembled cable tiewrap ● Version 1 for the C-profile: simple and universal cable fixing (of cables up to Ø 20mm and Ø 30mm diameter) ● Version 2 for standard rail 35: fixing by clipping onto a standard rail 35 CFB - strain relief connector system, modular and customised From page X 1434 ● Modular, customised plug-in system, many cables in a very tight space ● Can be installed in the mounting bracket or in front of the e-chain ® ● Available in 2 versions, cost-e ff ective and e ffi cient ● Quick installation with standard screw connection *Standard material: galvanised steel. Also available as stainless steel version (stainless steel material: 1.4301/AISI 304)